TEG Module

TEGFoam, simple heat transfer investigation

 

The following training case provided by Tobias Holzmann has some interesting background. The brief story is given in the »About« section. With the website re-launch and the complete freely available material, Tobias decided to add this case to the download section too. However, the case does not provide too much interesting insight but provides some interesting aspects. To investigate the case, one needs to compile the »TEGFoam« application. As different materials are used in the case without using the conjugate heat transfer solver, one has to handle the physics with a new solver. The main benefit is the usage of just one region while setting different material properties (diffusion coefficients) to the cells.

Image: Heat Distribution of the TEG test-bed
Image: Heat Distribution of the TEG test-bed close to the steady-state condition

Published under the GNU General Public License 3

Over the last ten years, Tobias tried to publish a wide range of different materials related to OpenFOAM® and CFD. You know it much better than he does if the content is worth to be supported. If you want to thank Tobias for the work he did, feel free to tell the community your opinion about the work Tobias Holzmann is doing or you can email your thoughts directly to »This email address is being protected from spambots. You need JavaScript enabled to view it.«. Keep in mind that the work that was done here took much time, and it is not self-evident that Tobias Holzmann shares all his work, knowledge, and attitude for free and keep the data up to date. Hosting the material, updating the data, and keeping up interesting work for the community does take much time and also money. Supporting Tobias is greatly welcomed and can be done easily by donating any amount you would like to give to support his projects shared on his website.

Support the work of Tobias Holzmann

The available OpenFOAM® training cases are tested and built for different OpenFOAM® versions (not distributions) on a Linux machine. During the tests, only the OpenFOAM Foundation version of OpenFOAM® was used. Furthermore, the following software packages are required for most of the training cases: Salome®, ParaView®, and for optimization tasks, one also needs the open-source software DAKOTA®. The OpenFOAM® cases might work with the ESI version of OpenFOAM® but it is not supported. For the OpenFOAM® extend project, the training cases will probably not work as the code diverged too much. Additionally, there is no support for Windows-based and MAC-based OpenFOAM® versions.

 

This offering is not approved or endorsed by OpenCFD Limited, producer and distributor of the OpenFOAM software via www.openfoam.com, and owner of the OPENFOAM® and OpenCFD® trade marks

Share the work on Your social network

Tobias would be grateful if you share his work on your social network in order to keep the OpenFOAM® community up to date. Furthermore, sharing the work will avoid that people investigate into topics, that are already prepared for your study such as the examples provided by Tobias Holzmann.

Released on 04.01.2021 — Downloads:
48
Released on 04.01.2021 — Downloads:
73
Released on 13.09.2021 — Downloads:
140
Released on 27.10.2024 — Downloads:
7